I am getting the following error running make:

Makefile:168: *** missing separator. Stop.

What is causing this?

1

14 Answers

As indicated in the online manual, the most common cause for that error is that lines are indented with spaces when make expects tab characters.

Correct

target: \tcmd

where \t is TAB (U+0009)

Wrong

target: ....cmd

where each . represents a SPACE (U+0020).

2

Just for grins, and in case somebody else runs into a similar error:

I got the infamous "missing separator" error because I had invoked a rule defining a function as

($eval $(call function,args))

rather than 

$(eval $(call function,args))

i.e. ($ rather than $(.

2

This is a syntax error in your Makefile. It's quite hard to be more specific than that, without seeing the file itself, or relevant portion(s) thereof.

For me, the problem was that I had some end-of-line # ... comments embedded within a define ... endef multi-line variable definition. Removing the comments made the problem go away.

1

My error was on a variable declaration line with a multi-line extension. I have a trailing space after the "\" which made that an invalid line continuation.

MY_VAR = \ val1 \ <-- 0x20 there caused the error. val2

In my case, I was actually missing a tab in between ifeq and the command on the next line. No spaces were there to begin with.

ifeq ($(wildcard $DIR_FILE), ) cd $FOLDER; cp -f $DIR_FILE.tpl $DIR_FILE.xs; endif

Should have been:

ifeq ($(wildcard $DIR_FILE), ) <tab>cd $FOLDER; cp -f $DIR_FILE.tpl $DIR_FILE.xs; endif

Note the <tab> is an actual tab character

In my case error caused next. I've tried to execute commands globally i.e outside of any target.

UPD. To run command globally one must be properly formed. For example command 

ln -sf ../../user/curl/$SRC_NAME ./$SRC_NAME

would become:

$(shell ln -sf ../../user/curl/$(SRC_NAME) ./$(SRC_NAME))

In my case, this error was caused by the lack of a mere space. I had this if block in my makefile:

if($(METHOD),opt) CFLAGS= endif

which should have been:

if ($(METHOD),opt) CFLAGS= endif

with a space after if.

In my case, the same error was caused because colon: was missing at end as in staging.deploy:. So note that it can be easy syntax mistake.

I had the missing separator file in Makefiles generated by qmake. I was porting Qt code to a different platform. I didn't have QMAKESPEC nor MAKE set. Here's the link I found the answer:

Just to add yet another reason this can show up:

$(eval VALUE)

is not valid and will produce a "missing separator" error.

$(eval IDENTIFIER=VALUE)

is acceptable. This sort of error showed up for me when I had an macro defined with define and tried to do

define SOME_MACRO ... some expression ... endef VAR=$(eval $(call SOME_MACRO,arg))

where the macro did not evaluate to an assignment.

I had this because I had no colon after PHONY

Not this,

.PHONY install install: install -m0755 bin/ytdl-clean /usr/local/bin

But this (notice the colon)

.PHONY: install ...

Following Makefile code worked:

obj-m = hello.o all: $(MAKE) -C /lib/modules/$(shell uname -r)/build M=$(PWD) modules clean: $(MAKE) -C /lib/modules/$(shell uname -r)/build M=$(PWD) clean
1

So apparently, all I needed was the "build-essential" package, then to run autoconf first, which made the Makefile.pre.in, then the ./configure then the make which works perfectly...

1