Losing the title to your beloved 1970 Honda CL175 can be a major inconvenience, especially when you need to make essential repairs or modifications. One such task that may arise is the need to remove the ignition. While this process can be daunting without the title, it is possible to accomplish it with a little ingenuity and determination. In this comprehensive guide, we will delve into the intricacies of removing the ignition from a 1970 Honda CL175 without a title, providing step-by-step instructions, valuable tips, and helpful resources to ensure a successful outcome.
Before embarking on this task, it is crucial to gather the necessary tools and materials. You will need a set of screwdrivers, pliers, a hammer, a punch, and a new ignition switch. Additionally, it is advisable to have a Haynes or Clymer manual for your specific Honda model to guide you through the process. Once you have assembled the necessary equipment, you can begin the ignition removal process by disconnecting the negative terminal of the battery. This safety precaution will prevent any electrical accidents during the procedure.
Next, locate the ignition switch on the right side of the handlebar. It is typically secured by two screws, which you can remove using a screwdriver. Once the screws are removed, gently pull the ignition switch out of its housing. Disconnect the electrical connectors from the back of the switch and note their positions for reassembly later. With the ignition switch removed, you can now access the ignition lock cylinder. This cylinder is held in place by a retaining ring, which can be removed using a pair of pliers. Once the retaining ring is removed, carefully slide the ignition lock cylinder out of the housing. Be mindful of any small springs or pins that may fall out during this process.
How to Remove Ignition from 1970 Honda CL175
1. Turn the handlebars to the left and locate the ignition switch on the right side of the gas tank.
2. Insert the key into the ignition switch and turn it to the “OFF” position.
3. Remove the key and grasp the ignition switch.
4. Pull the ignition switch straight out of the gas tank.
5. Disconnect the electrical connector from the back of the ignition switch.
6. The ignition switch is now removed.
People Also Ask
How do I replace the ignition switch on a 1970 Honda CL175?
To replace the ignition switch on a 1970 Honda CL175, follow these steps:
1. Remove the old ignition switch.
2. Connect the new ignition switch to the electrical connector.
3. Insert the new ignition switch into the gas tank.
4. Turn the handlebars to the right and tighten the ignition switch.
5. Insert the key and turn it to the “ON” position.
How do I remove the lock cylinder from a 1970 Honda CL175?
To remove the lock cylinder from a 1970 Honda CL175, follow these steps:
1. Remove the ignition switch.
2. Locate the two screws that secure the lock cylinder to the ignition switch.
3. Remove the screws.
4. Pull the lock cylinder straight out of the ignition switch.
Do I need to replace the whole ignition switch assembly
You may not need to replace the whole ignition switch assembly. If the lock cylinder is the only part that is damaged, you can replace just the lock cylinder.
